Portafiltros de acero inoxidable HIN, CHMLAB®
Filtración de muestras acuosas, disolventes y productos químicos
CHM® HIN inox holder for solvents and chemicals.
The PTFE-coated surface on the top part is an important property of the filter holder and ensures leak proof sealing without a sealing ring.
The temperature resistance is extremely good, and the chemical compatibility depends only on the used membrane filter type.
Sterilisation: by autoclaving (max. 134 ºC) or by dry heat (max. 180 ºC).
The top part can easily be mounted on the bottom part using the tightening tool supplied.
Filter supports in the top and bottom parts allow filtration in either direction.
| TECHNICAL SPECIFICATIONS | ||
| MEMBRANE FILTER | 25 mm | 47 mm (in line) |
| Filtration area | 3 cm2 | 13 cm2 |
| Flow rates Typical values per cm2 for water at 1 bar (100 kPa) differential pressure: |
45 ml/min (0.2 μm filter) 80 ml/min (0.45 μm filter) |
0.5 l/min (0.2 μm filter) 1.0 l/min (0.45 μm filter) |
| Max. operating pressure |
7 bar (700 kPa) | 20 bar (2000 kPa) |
| Chemical compatibility | As for stainless steel and PTFE | |
| Sterilization | By autoclaving (max 134 ºC) or by dry heat (max 180 ºC) | |
